Pro Power 12V 200ah Lithium Iron LiFePo4 Deep Cycle Battery Solar 4WD Caravan

3 Year Warranty, FRESH STOCK, Free shipping

In Stock

Calculate Shipping

You may be deceived by how easy this battery is to transport, it’s so lightweight when compared to its lead acid counterparts! Providing a massive Pro Power 200ah of 12V power at a fraction of the weight of traditional batteries, this is a must buy! Lithium technology is one of the leaders in battery technology at the moment, and is fast becoming recognised as more sustainable, more environmentally friendly, and better performing. As the shape as identical to that of a lead acid battery, they will easily fit into any system designed to take a lead acid battery, but with improved performance, longer cycle life and lower discharge rates, can you really justify choosing a lead acid battery over this? As it uses lithium in place of heavy and polluting lead, when this battery has reached the end of its useful life, it is more environmentally friendly to dispose of.


  • Ultra light weight
  • Life cycles 1500-5000
  • High energy density
  • Does not need prolonged priming when new. One regular charge is all that's needed.
  • Internal cell balancing
  • low self-discharge
  • Can be charged using most standard lead acid battery chargers (Set for agm/gel cells)
  • Climate Resistance
  • No Peukert's Loss
  • No Voltage sag
  • Maintenance free
  • Can be used in series or parallel
  • 3 Years Warranty


Battery Pack / Cell specification


Combination method




Nominal voltage


Max. charge voltage


Discharge cut-off voltage


Max Charge current 


Max Working current


Pack Impedance standard


Weight (Approx.)

21.2 kg

Max. dimension(L×W×H)(mm)


Operating  temperature

Charge temperature


Discharge temperature


Single cell over-charge cut-off voltage



3 Years







rated voltage(V)


Typical Impedance (mΩ)


Battery material


over-charge release voltage


Single cell under-discharge cut-off voltage

2. 5V

Discharge release voltage

2. 5V

Over-discharge cut-off current


Over-discharge cut-off current delay


Short-circuit protection


Short-circuit protection delay


Condition for the recovery of over-current and Short-circuit

remove load, auto recover

Balance current


Balance Condition



Test Conditions

1. Standard Test Conditions
Test should be conducted with new batteries within one week after shipment from our factory and the cell shall not be cyded more than five times before the test. Unless otherwise specified,test and measurement shall be done under temperature of 20±5℃ and relative humidity of 45~48%.if it is judged that the test results are not affected by such conditions,the tests may be conducted at temperature 15~30℃ and humidity 25-85%R.H.

  • Measuring Instrument or Apparatus
    • Dimension Measuring Insturment

The dimension measurement shall be implemented by instruments with equal or more precision scale of 0.01mm.

2.  Voltager
Standard class specified in the national standard or more sensitive class having inner impedance more than 10kΩ/V.

  • Ammeter

Standard class specified in the national standard or more sensitive class.Total extermal resistance including ammeter and wire is less than 0.01Ω.

  • Impedance Meter

Impedance shall be measured by a sinusidal alternating current method(1kHz LCR meter)

  • Standard Charge/Discharge
    • Standard charge:Test procedure and its criteria are referred as follows:
      0.2C5A= Charging shall consist of charging at a 0.5 C5A constant current rate until the cell reaches 14.6V. The cell shall then be charged at constant voltage 0f 14.6 volts while tapreing the charge current Charging shall be terminated when the charging current has tapreed to 0.02 C5A.Charge time:Approx 6.0h,The cell shall demonstrate no permanent degradation when charged between 0℃ and 45℃.
    • Standard Discharge: 0.2 C5A= Cells shall be discharged at a constant current of 0.2 C5A to 10.0 volts @20℃±5℃.
    • If no otherwise specified,the rest time between Charge and Discharge amount to 30min.


Appearance,Initial Performance Test

Initial Performance Test


Test Method and Condition


Open-Circuit Voltage

The open-circuit voltage shall be measured within 24 hours after standard charge.


Internal impedance

Internal resistance measured at AC 1KHz after 50% charge.


Minimal Rated Capacity

The capacity on 0.2C5A discharge till the voltage tapered to 10.0V shall be measured after rested for 30min then finish standard charge.

Discharge Capacity


Cycle Life and Leakage-Proof




Test Conditions


Cycle Life
(0.5 C5A)

Higher than 70% of the Initial Capacities of the Cells

Carry out 1500 cycle
Charging/Discharging in the below condition.

  • Charge:Standard Charge
  • Discharge:0.5 C5A to 10.0V
  • Rest Time belween charge/discharge:30min.
  • Temperayure:20±5℃



No leakage
(visual inspection)

After full charge with standard charge,store at 60±3℃,60±10%RH for 1 month.


Mechanical characteristies and Safety Test
(Mechanical characteristies)



Test Method and Condition



Vibration Test

After standard charging,fixed the cell to vibration table and subjection cycling that the frequeney is to be varied at the rate of 1Hz per minute between 10Hz an 55Hz,the excursion of the vibration is 1.6mm.The cell shall be vibrated for 30minutes per axis of XYZ axes.

No leakage

No fire


Drop Test

The cdll is to be dropped from a height of 1 meter twice conto concrete ground.

No explosion, No fire,no leakage.



Battery Condition

Test Method



Fresh,Fully charged

Crush between two flat plates.Applied force is about 13kN(1.72Mpa) for 30min.

No explosion,No fire

Short Circuit

Fresh,Fully charged

Each test sample battery,in turn,is to be short-circuited by conneting the (+)and (-) terminals of the battery with a Cu wire having a maximum resistance load of 0.1Ω. Test are to be conducted at room temperature (20℃±2℃).

No explosion,No fire.The Temperature of the surface of the Cells are lower than 150℃

Short Circuit

Fresh,Fully charged

Each test sample battery,in turn,is to be short-circuited by connecting the (+)and (-) terminals of the battery with a Cu wire having a maximum resistance load of 0.1Ω. Test are to be conducted at temperature (60℃±2℃).

No explosion,No fire.The Temperature of the surface of the Cells are lower than 150℃


Fresh,Fully charged

A 56mm diameter bar is inlayed into the bottom of a 10Kg weight.And the weight is to be dropped from a height of 1m onto a sample battery and then the bar will be across the center of the sample.

No explosion,No fire

Forced Discharge

Fresh,Fully charged

Discharge at a current of 1 C5A for 2. 5h.

No explosion,No fire

Nail Pricking

Fresh,Fully charged

Prick through the sample battery with a nail having a diameter of 3mm and remain 2h.

No explosion,No fire


SKU PP-Li-12V-200AH
Brand Pro Power
Shipping Weight 21.2000kg
Shipping Width 0.530m
Shipping Height 0.220m
Shipping Length 0.240m
Assembled Length 0.240m
Assembled Height 0.220m
Assembled Width 0.530m

Thank you Thank you Thank you....!!!

By: on 28 November 2018
6 months ago, we installed one of these ProPower 200ah Lithium batteries into our Roadstar caravan in preparation for our 12 month round Australia trip. We previously had 2 x 120ah AGM batteries and, while they were good quality, they couldn't handle our power requirements for prolonged periods. We would find ourselves approaching 40% SOC even after one night freecamping. What's more, they took for ever to get back to full charge. We were constantly monitoring our battery readout in the hope we wouldn't damage our expensive batteries. Now, with the ProPower lithium battery installed, we no longer have any of these issues. This battery performs well above expectations. It delivers a constant high voltage even at 60% SOC. We never see the battery monitor fall below 12.8 volts. What really impresses me is how quickly we get back to 100% SOC. We can now confidently run all our devices and accessories without any concern about damaging our battery. The icing on the cake is we have saved in excess of 45KG swapping to the much lighter lithium battery. Given we live in our caravan, we need all the cargo capacity we can get. This battery has helped us to keep our caravan under its legal weight limits. The 3 years warranty gave us piece of mind this battery will last the distance. Thank you so much OziMall and ProPower. You have given us the confidence to freecamp for extended periods with plenty of 12v power in hand.

Write a product review

Others Also Bought

More From This Category